DATRON Double Flute End Mill – Stepped

DATRON double flute end mills are available in special models. With extra short cutting edge, toric cut, or stepped.

• Micrograin solid carbide end mill
• with two flutes and flat bottom
• 30° upcut spiral
• shank without clamping surface DIN 6535-HA

With stepped double flute end mills, the cutting edge diameter is considerably larger than the shaft diameter. This tool is ideally suited for milling over. With high feed rates and low infeed, large surfaces can be milled over in a short time. Due to the sharp-edged corners, it is also possible to perform contour machining.